HYDROPLAST 520GR
NEW GENERATION, HIGH RANGE WATER
REDUCING SUPER PLASTICISING ADMIXTURE
Product Description
Hydroplast 520GR is classified as high-range
super plasticizing admixture according to ASTM C-494.
It is a PCE based, new generation water reducing,
slump retaining and strength enhancing admixture
- Can be used to manufacture wide range
of concrete - Hydroplast 520GR is compatible with all
grade of cement. - Early compressive strength is achieved as
a result of the low water/cement ratio - Reduced thermal peak for casting in hot
weather - High slump retention rate for distance
transportation of concrete - Quality concrete at low cost
- Pre-stressed concrete
- Ready-mix concrete
- Pre-cast concrete
- Industrial beams
- Slab bases
Hydroplast 250GPS is available in 1000L, 210L, 25L,
and 20L. this product is available on demand.
12 months stored in a cool dry place.
Hydroplast 520GR has a shelf life of 12 month starting
from manufacturing date, provided no other chemical
is added to it.
The product should be stored at room temperature,
away from direct sun light, and frost in clean dry tank.
After freezing, the properties of hydroplast 520GR can
be recovered by controlled thawing and agitation.
Do not allow the product to be exposed for long
period of time.
Armorsil provides detailed method statements
on all its products for use in various applications.
Below is an information summary for guidance
Hydroplast 520GR dosage is determine in trial batch
taking into account the local condition affecting the
workability of the fresh mix and the mechanical
properties required. To serve as guide, we
recommend using 0.8 to 1.2% of the cementitious
material.
Conforms to the requirements of BS EN 934-2
Table 9
Appearance: White
Like all material that contains Portland cement,
this material must be handled professionally as
it can cause irritation and burns. Therefore
contact with skin and eyes must be avoided.
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but
accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty either expressed or
implied. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. Nothing contained in any supplied materials relieves the user of the obligation to read and follow the warnings and instruction for each product as set forth in the current Technical Data Sheet, product label and Safety Data Sheet prior to product use away. Armorsil Manufacturing supplies products that comply with the properties shown on the current datasheets. In the unlikely event that products supplied are proved not to comply with these properties, then we will replace the non-compliant product or refund the purchase price. Armorsil Manufacturing does not warrant or guarantee the installation of the products as it does not have control over the installation or end use of the products. Any suspected defects must be reported to Armorsil Manufacturing in writing within seven working days of being detected. Armorsil Manufacturing. Makes no warranty as to merchantability or fitness for a particular purpose and this warranty is in lieu of all other warranties express or implied. Neither seller nor Armorsil Manufacturing shall be liable to the buyer or any third person for any injury, loss or damages of any sort including remote or consequential damages, down time, or delay directly or indirectly resulting from use of or inability to use the product. . The information contained in the latest data sheet supersedes all previously published editions. Visits to site by Armorsil personnel do not constitute supervisory responsibility. Armorsil reserves the right to alter the information contained in this datasheet without prior notice
